Post by photo2000a on Nov 24, 2008 9:00:43 GMT -5
HI
Rather new to using a VNA, hope this isn't too obvious...and I was fiddling around with the values in the box to add the values for my coax, was going to use the feature to 'filter out' the coax and read the antenna.
So I think I half aborted that process since I was missing some coax data, but realize that I don't remember what was in there as it's default, is there a on/off function 'check box' or do I just set everything to 0?
On a separate note, since that was the only thing i really poked around with my dipole, measurements smith chart looked mostly ok, as expected, but nothing went thru the center or near it just round and round, so i thought perhaps I screwed up the above
any tips appreciated
Rather new to using a VNA, hope this isn't too obvious...and I was fiddling around with the values in the box to add the values for my coax, was going to use the feature to 'filter out' the coax and read the antenna.
So I think I half aborted that process since I was missing some coax data, but realize that I don't remember what was in there as it's default, is there a on/off function 'check box' or do I just set everything to 0?
On a separate note, since that was the only thing i really poked around with my dipole, measurements smith chart looked mostly ok, as expected, but nothing went thru the center or near it just round and round, so i thought perhaps I screwed up the above
any tips appreciated