Post by Deleted on Nov 3, 2017 6:56:51 GMT -5
Hi,
The StereoScope plug-in will display the signal at the location where it has been put in the DAW. So in your case, if you are using the DAW's pan controls, you will need to insert the plug-in after the pan pot. I guess that post-fader slots should do the trick (or on an aux bus if you are using busses)."
No idea how to add post-faders.
I have tried this (I am using Kontakt 5):
If I put the analyzer before Kontakt > No result at all (no input).
After Kontakt > Always centered.
The only thing that does work, is panning the instrument in Kontakt, but this is not what I want.
Any ideas?
Please help.
Thanks!
I didn't find the right solution from the Internet.
References forum.thingyos.com/showthread.php?t=147250
demo video
The StereoScope plug-in will display the signal at the location where it has been put in the DAW. So in your case, if you are using the DAW's pan controls, you will need to insert the plug-in after the pan pot. I guess that post-fader slots should do the trick (or on an aux bus if you are using busses)."
No idea how to add post-faders.
I have tried this (I am using Kontakt 5):
If I put the analyzer before Kontakt > No result at all (no input).
After Kontakt > Always centered.
The only thing that does work, is panning the instrument in Kontakt, but this is not what I want.
Any ideas?
Please help.
Thanks!
I didn't find the right solution from the Internet.
References forum.thingyos.com/showthread.php?t=147250
demo video