|
Post by phenol on Sept 28, 2017 14:35:35 GMT -5
Port A amplitude drops down as expected in single freq mode when some of the amplitude control buttons is clicked, but I can’t seem to get it to drop below ‘100%’ in port A or B scan mode. The amplitude level is correctly identified on the screen, but it doesn’t appear to drop below ~-12dBm as seen on a spectrum analyzer. I am doing a narrowband scan from 55 to 56 MHz with a small step such that it can be captured by the spectrum analyzer. I am using the latest software (635). How can I reduce signal amplitude in scan mode?
|
|