frequencies & defaults

[kdrolt]

The frequency units are defaulted as MHz. Is there a way to set the default to kHz ?

This applies to not only the limits on a measurement span, but also to the number + units shown on a graph. Thx.

[w0qe]

You can already enter frequencies in KHz by entering the letter "k" after the number such as 10000k for 10.000Mhz. However the graph always displays the units as MHz owing to the fact that this is an RF analyzer. The axis's on the graph are automatically divided up into a reasonable number of divisions and labeled quite well normally which is very convenient and requires little user input.

Just my $.02.

Larry, W0QE

[kdrolt]

Thx Larry.

I knew about the prefixes, but I do a lot of work below 1 MHz. The 4170 can measure down to 5 kHz, and a lot of the resonators I test are in the 10 kHz to 300 kHz range.