kt9b
New Member
Posts: 3
|
Post by kt9b on Jan 4, 2010 17:37:01 GMT -5
How do I go about changing the step freq so that it is reflected in the exported .csv file. I have changed in in the aim under limits but it seems stuck stepping .06MHZ which is too large a step for my purposes.
Thanks
Rick
|
|
|
|
Post by Bob on Jan 4, 2010 17:51:37 GMT -5
Hi Rick,
The value in the csv file should be the same as the step size you entered with the scan limits. If you enter a small value for the step and the range is large so that more than 300 points would be required for the scan, then the step size will be set to a value that gives 300 pints. This number will be increased to 20000 in the new update which will be available in a couple of days.
There is a small error in the freq values printed in the csv file due to insufficient precision in the calculations for this file data. This will also be fixed in the update.
--73/ Bob
|
|
