|
Post by kweijand on Oct 3, 2015 14:20:08 GMT -5
I'm testing a small LNA, but the system complains about port B overload, even though the port should be able to handle more than +6dBm ? I added a 20dB pad to on the drive portA so the input of the amp is around -33dBm giving a -12 dBm input into port B, still the SW complains about overload. how to adjust it ? I'd like to set the drive power to 10% only during the scan, but this means a new cal with lower portB 0dB level, and it creates overload message again when using an amp.
|
|