ba4tb
New Member
Posts: 5
|
Post by ba4tb on Nov 3, 2014 5:59:01 GMT -5
We are using 4170D to measure a number of the RFID devices. The issue is that when we connect the 4170D to SDK,it works,but the connection failed after several devices measured,this will need to re-boot the program and re-connect the 4170D! It happened again and again,everytime it will be hard to connect,and the measurement becomes inaccurate! The error massage is 34525 What is the problem with this? regards, Dale
|
|
|
Post by Bob on Nov 3, 2014 18:52:02 GMT -5
This error indicates a comm problem:
34525 => Data was not received from the AIM due to a comm problem
There is a similar problem indicated by error number 34526. This error code was left out of the manual but I've updated it now.
Be sure the measurements can be made with program version: AIM_863.exe. If this program runs consistently, the DLL should work.
Be sure your application program waits long enough for the data to be received from the AIM before sending another command. A timeout in msec of (25 + 1.5*Averaging_Value) will probably be enough.
-73/Bob
|
|
ba4tb
New Member
Posts: 5
|
Post by ba4tb on Nov 4, 2014 3:27:33 GMT -5
Thanks Bob,
We use AIM863.And would like to know how to solve the problem or how to what the parameters in the program could be set? Thanks again!
73,Dale
|
|